Description / Application Outdoor  section designed for ground level or rooftop application. "A" indoor section versatile up, horizontal, or counterflow air flow designed for use with CPKT outdoor section. The "A" unit may be located in closet, utility room, attic, or basement. "AW" vertical wall mount designed to be installed on top of water heater or recessed into wall in vertical upflow position. "U", "UC", "H" fanless indoor coils for add-on heat pump application.	Standard Equipment Copper tube, aluminum fin coil construction. Brass suction and liquid shut off valves with sweat Connections. Totally enclosed permanently lubricated condenser fan motor. Quiet operating top discharge. Fully charged for 25' of tubing legnth. Discharge line muffler. Low pressure control for loss of charge protection. Built-in mild ambient control to 45 degree. Hermetically sealed compressor. Bi-flow Liquid line filter drier. Suction line accumulator. Check-flowrator expansion device. Crankcase heater (where indicated) Time initiate, temperatue terminate defrost. Bottom pan rails elevating unit above slab. Compressor internal high pressure control.
	Cabinet Construction Beige baked enamel finish with 500 hour salt spray approval. Heavy gauge / zinc clad.	Accessories  Standard room thermostat with 2 stage heat, 1 stage cool and emergency heat, Model HPT18-60. Automatic change-over room thermostat with 2 stage heat, 1 stage cool and emergency heat capability, Model HPTA18-60. Outdoor thermostats, Model OT18-60. Emergency heat relay, Model EF18-60. All fuel, Model AFE18-60. DFK Downflow Kits.